| 1 | <sect2><title> </title><para> </para></sect2>
|
|---|
| 2 |
|
|---|
| 3 | <sect2>
|
|---|
| 4 | <title>Installation of Fileutils</title>
|
|---|
| 5 |
|
|---|
| 6 | <para>The programs from a statically linked Fileutils package may cause
|
|---|
| 7 | segmentation faults on certain systems, if your distribution has
|
|---|
| 8 | Glibc-2.2.3 installed. It seems to happen mostly on machines
|
|---|
| 9 | powered by an AMD CPU, but there is a case or two where an Intel system
|
|---|
| 10 | is affected as well. If your system falls in this category, apply the
|
|---|
| 11 | patch.</para>
|
|---|
| 12 |
|
|---|
| 13 | <para>Note that in some cases using this patch will result in not being
|
|---|
| 14 | able to compile this package at all, even when your system has an AMD CPU
|
|---|
| 15 | and has Glibc-2.2.3 (or higher) installed. If that's the case, you'll need
|
|---|
| 16 | to remove the fileutils-&fileutils-version; directory and unpack it again
|
|---|
| 17 | from the tarball before continuing. We believe this may be the case when
|
|---|
| 18 | your distribution has altered Glibc-2.2.3 somehow, but details are
|
|---|
| 19 | unavailable at this time.</para>
|
|---|
| 20 |
|
|---|
| 21 | <para>To fix this package to compile properly on AMD/Glibc-2.2.3
|
|---|
| 22 | machines, run the following command. Do <emphasis>NOT</emphasis>
|
|---|
| 23 | attempt this fix if you don't have Glibc-2.2.3 installed. It will more
|
|---|
| 24 | than likely result in all kinds of compile time problems.</para>
|
|---|
| 25 |
|
|---|
| 26 | <para><screen><userinput>patch -Np1 -i ../fileutils-&fileutils-patch-version;.patch</userinput></screen></para>
|
|---|
| 27 |
|
|---|
| 28 | <para>Install Fileutils by running the following commands:</para>
|
|---|
| 29 |
|
|---|
| 30 | <para><screen><userinput>LDFLAGS="-static" \
|
|---|
| 31 | ./configure --disable-nls --prefix=$LFS/static
|
|---|
| 32 | make
|
|---|
| 33 | make install</userinput></screen></para>
|
|---|
| 34 |
|
|---|
| 35 | <para>Once you have installed Fileutils, you can test whether the
|
|---|
| 36 | segmentation fault problem has been avoided by running
|
|---|
| 37 | <userinput>$LFS/static/bin/ls</userinput>. If this works, then you are OK. If
|
|---|
| 38 | not, then you need to re-do the installation with the patch if you didn't
|
|---|
| 39 | use it, or without the patch if you did use it.</para>
|
|---|
| 40 |
|
|---|
| 41 | </sect2>
|
|---|
| 42 |
|
|---|
