source: README.CLFS@ 0f3b1c3

ablfs-more legacy trunk
Last change on this file since 0f3b1c3 was fd4a798, checked in by Pierre Labastie <pierre.labastie@…>, 3 years ago

Remove $Id$ comments, they are useless with git

  • Property mode set to 100644
File size: 1.7 KB
Line 
1 CLFS-1.x NOTES
2
3 None for now.
4
5
6
7 CLFS SYSROOT METHOD NOTES
8
9 .- If you want to install additional custom packages via "Add custom tools
10 support" and/or select "Add blfs-tool support", be sure to review and edit
11 their packages build scripts to follow the sysroot build method or you will
12 end messing your host system. Be very careful with this.
13
14 .- If you install additional packages not using the "Add custom tools support"
15 feature (i,e, you will install it manually after finished the Makefile run)
16 you will need to run manually the "Changing the Ownership Of The CLFS System"
17 phase commands found in the book.
18
19
20
21 CLFS EMBEDDED SYSTEMS NOTES
22
23 .- Mips, WRT and ARM builds are broken due a book bug on the uClibc
24 *ENDIAN* configuration settings.
25
26 .- To install CBLFS packages you must to use the "Add custom tools support"
27 feature. To learn how it works and how to use it, see the section titled
28 "Adding Post-System Build Configuration Files and Extra Packages"
29 found in README.CUSTOM. That is also applicable to bootloaders installation.
30
31 .- If you install additional packages not using the "Add custom tools support"
32 feature (i,e, you will install it manually after finished the Makefile run)
33 you will need to run manually the "Changing the Ownership Of The CLFS System"
34 phase commands found in the book.
35
36 .- If your target is a MIPS wireless router, you must to select "mips" as
37 your target architecture and "WRT - MIPS based wireless route" as your
38 hardware platform.
39
40 .- The backup & clean-up phases aren't run. This is to allow users to
41 review the installed files and do a more in-deeper clean-up before creating
42 the system tarball.
Note: See TracBrowser for help on using the repository browser.