Configuring <application>NCPFS</application> Config files ~/.nwclient Configuration Information A config file ~/.nwclient should be placed in the home directory of each user that intends to use ncpfs. The permissions on this file should be set to 600, for obvious security reasons. The configuration file should contain a single line per server that the user will use. Each line should contain the server name, the user name, and optionally the password. Below is a sample .nwclient file. # Begin example ~/.nwclient config file Server1/User1 Password Server2/User1 Server2/Guest1 - # End example .nwclient config file The syntax for the .nwclient file is simple, server_name/user_name password. Be extremely careful when creating or editing this file as the client utilities are very picky about syntax. There should always be a space immediately after the username. If this space is substituted by a tab or multiple spaces, you will not get the expected results when attempting to use the NCPFS tools. If no password is supplied, the client utilities will ask for a password when it is needed. If no password is needed, for instance when using a guest account, a single '-' should be put in place of a password. It should be noted that the ncpmount is not intended to mount individual volumes because each mount point creates a separate client connection to the Novell server. Mounting each individual volume separately would be unwise, as mounting all volumes on a server under one mount point uses only one client connection. If you need to set up the IPX protocol at boot, you can install the /etc/sysconfig/network-devices/services/ipx network service script included with the package. make install-service-ipx Next install the configurations script, ifconfig.ipx0. The configuration assumes IPX will be set up on eth0 and the network frame type is 802.2. You should confirm that these are the correct settings and adjust as necessary. Note: This will overwrite any existing file. cat > /etc/sysconfig/network-devices/ifconfig.ipx0 << "EOF" ONBOOT=yes SERVICE=ipx IPXDEV=eth0 FRAME=802.2 EOF