%general-entities; ]> The Net-tools package is a collection of programs for controlling the network subsystem of the Linux kernel. Download (HTTP): Download (FTP): Download size: &net-tools-size; Estimated Disk space required: &net-tools-buildsize; Estimated build time: &net-tools-time; If you don't know what to answer to all the questions asked during the make config phase below, then just accept the defaults. This will be just fine in the majority of cases. What you're asked here is a bunch of questions about which network protocols you've enabled in your kernel. The default answers will enable the tools from this package to work with the most common protocols: TCP, PPP, and several others. You still need to actually enable these protocols in the kernel—what you do here is merely telling the package to include support for those protocols in its programs, but it's up to the kernel to make the protocols available. Install Net-tools by running the following commands: yes "" | make config && make && make update yes "" | make config: We skip all the questions and accept the defaults. The Net-tools package contains arp, dnsdomainname (link to hostname), domainname (link to hostname), hostname, ifconfig, nameif, netstat, nisdomainname (link to hostname), plipconfig, rarp, route, slattach and ypdomainname (link to hostname). arp is used to manipulate the kernel's ARP cache, usually to add or delete an entry, or to dump the entire cache. dnsdomainname reports the system's DNS domain name. domainname reports or sets the system's NIS/YP domain name. hostname reports or sets the name of the current host system. ifconfig is the main utility for configuring network interfaces. nameif names network interfaces based on MAC addresses. netstat is used to report network connections, routing tables, and interface statistics. nisdomainname does the same as domainname. plipconfig is used to fine tune the PLIP device parameters, to improve its performance. rarp is used to manipulate the kernel's RARP table. route is used to manipulate the IP routing table. slattach attaches a network interface to a serial line. This allows you to use normal terminal lines for point-to-point links to other computers. ypdomainname does the same as domainname.