/etc/ppp/pppoe.conf, /etc/ppp/firewall-standalone, /etc/ppp/firewall-masq, /etc/ppp/pppoe-server-options, /etc/resolv.conf, /etc/ppp/pap-seecrets, /etc/ppp/chap-secrets To configure RP-PPPoE after installation, you should run the adsl-setup script. When configuring your connection, you will need to have your ISP's nameserver information available, as well as your username and password. You will also be asked whether to configure a dial-on-demand or a constant connection. If your service provider does not charge by the minute, it is usually good to have a bootscript handle the connection for you. You can, of course, choose not to install the following script, and start your connection manually with the adsl-start script. Use the following commands to create the optional adsl bootscript: cat > /etc/rc.d/init.d/adsl << "EOF" #!/bin/bash # Begin $rc_base/init.d/adsl # Based on sysklogd script from LFS-3.1 and earlier. # Rewritten by Gerard Beekmans - gerard@linuxfromscratch.org # adsl script written by DJ Lucas - dj@lucasit.com source /etc/sysconfig/rc source $rc_functions case "$1" in start) echo "Bringing up the ADSL interface..." /usr/sbin/adsl-start evaluate_retval ;; stop) echo "Bringing down the ADSL interface..." /usr/sbin/adsl-stop evaluate_retval ;; restart) $0 stop sleep 1 $0 start ;; status) /usr/sbin/adsl-status ;; *) echo "Usage: $0 {start|stop|restart|status}" exit 1 ;; esac # End $rc_base/init.d/adsl EOF chmod 755 /etc/rc.d/init.d/adsl Now create the necessary symlinks: ln -sf ../init.d/adsl /etc/rc.d/rc0.d/K49adsl && ln -sf ../init.d/adsl /etc/rc.d/rc1.d/K49adsl && ln -sf ../init.d/adsl /etc/rc.d/rc2.d/K49adsl && ln -sf ../init.d/adsl /etc/rc.d/rc3.d/S24adsl && ln -sf ../init.d/adsl /etc/rc.d/rc4.d/S24adsl && ln -sf ../init.d/adsl /etc/rc.d/rc5.d/S24adsl && ln -sf ../init.d/adsl /etc/rc.d/rc6.d/K49adsl