source: pst/scanning/sane/sane-inst.xml@ 47c5ee8

10.0 10.1 11.0 11.1 6.0 6.1 6.2 6.2.0 6.2.0-rc1 6.2.0-rc2 6.3 6.3-rc1 6.3-rc2 6.3-rc3 7.10 7.4 7.5 7.6 7.6-blfs 7.6-systemd 7.7 7.8 7.9 8.0 8.1 8.2 8.3 8.4 9.0 9.1 basic bdubbs/svn elogind gnome kde5-13430 kde5-14269 kde5-14686 krejzi/svn lazarus nosym perl-modules qt5new systemd-11177 systemd-13485 trunk upgradedb v5_0 v5_1 v5_1-pre1 xry111/intltool xry111/test-20220226
Last change on this file since 47c5ee8 was 47c5ee8, checked in by Mark Hymers <markh@…>, 19 years ago

add --sysconfdir=/etc to SANE instructions

git-svn-id: svn://svn.linuxfromscratch.org/BLFS/trunk/BOOK@1402 af4574ff-66df-0310-9fd7-8a98e5e911e0

  • Property mode set to 100644
File size: 1.4 KB
Line 
1<sect2>
2<title>Installation of <application><acronym>SANE</acronym></application></title>
3
4<sect3><title>Preparing your system for scanner access</title>
5<para>To access your scanner, you will probably need the related kernel
6drivers. A <acronym>SCSI</acronym> scanner will need <acronym>SCSI</acronym>
7 drivers, a parallel port scanner needs parallel port support (you should use
8enhanced <acronym>EPP</acronym> modes) and an <acronym>USB</acronym> scanner
9will need the <acronym>USB</acronym> scanner module and a <acronym>SCSI
10</acronym> system for emulation. Be sure that you have got the necessary
11devices to access the drivers.</para>
12</sect3>
13
14<sect3><title>Installation of <application><acronym>SANE</acronym></application> backends</title>
15
16<para>Install <application><acronym>SANE</acronym></application> backends by
17running the following commands:</para>
18
19<screen><userinput><command>./configure --prefix=/usr --sysconfdir=/etc &amp;&amp;
20make &amp;&amp;
21make install</command></userinput></screen>
22
23</sect3>
24
25<sect3><title>Installation of <application><acronym>SANE</acronym></application> front ends</title>
26
27<para>To install <application><acronym>SANE</acronym></application> front ends, use the following
28commands:</para>
29
30<screen><userinput><command>./configure --prefix=/usr &amp;&amp;
31make &amp;&amp;
32make install</command></userinput></screen>
33
34</sect3>
35
36</sect2>
Note: See TracBrowser for help on using the repository browser.