%general-entities; ]> Here are some things you should know about building each package: Several packages are patched before compilation, but only when the patch is needed to circumvent a problem. A patch is often needed in both the current and the following chapters, but sometimes, when the same package is built more than once, the patch is not needed right away. Therefore, do not be concerned if instructions for a downloaded patch seem to be missing. Warning messages about offset or fuzz may also be encountered when applying a patch. Do not worry about these warnings; the patch was still successfully applied. During the compilation of most packages, some warnings will scroll by on the screen. These are normal and can safely be ignored. These warnings are usually about deprecated, but not invalid, use of the C or C++ syntax. C standards change fairly often, and some packages have not yet been updated. This is not a serious problem, but it does cause the warnings to appear. Check one last time that the LFS environment variable is set up properly: echo $LFS Make sure the output shows the path to the LFS partition's mount point, which is /mnt/lfs, using our example. Finally, two important items must be emphasized: The build instructions assume that the , including symbolic links, have been set properly: bash is the shell in use. sh is a symbolic link to bash. /usr/bin/awk is a symbolic link to gawk. /usr/bin/yacc is a symbolic link to bison, or to a small script that executes bison. Here is a synopsis of the build process. Place all the sources and patches in a directory that will be accessible from the chroot environment, such as /mnt/lfs/sources/. Change to the /mnt/lfs/sources/ directory. For each package: Using the tar program, extract the package to be built. In and , ensure you are the lfs user when extracting the package. Do not use any method except the tar command to extract the source code. Notably, using the cp -R command to copy the source code tree somewhere else can destroy links and timestamps in the source tree, and cause the build to fail. Change to the directory created when the package was extracted. Follow the instructions for building the package. Change back to the sources directory when the build is complete. Delete the extracted source directory unless instructed otherwise.